How do I work out the dose from a 5mg NR vial for a beginner stack?
Posted by fasted_scientist in Beginner Questions - 11 points, 8 comments.
Hey folks, I’m completely new to peptides and just got a 5mg vial of NR (nicotinamide riboside). I’ve read that the typical oral dose is somewhere between 250‑1000 mg per day, but I’m totally lost on how to translate that into how much bacteriostatic water to add and how much to pull into a syringe. I’ve seen people talk about “mg per ml” after reconstitution but I’m not sure if I’m supposed to aim for a certain concentration or just dilute it all and then measure out the volume I need.
Could someone walk me through the maths step by step, assuming I want to start at the lower end of the range? Also, if I’m planning to stack NR with Kisspeptin‑10 and Gonadorelin later, does the reconstitution method change for each peptide or can I use the same water volume for all? Thanks for any beginner‑friendly tips.
Comments
- curious_scientist: I’ve done this a few times with NR and other powders. First decide the concentration you want – say 10 mg per ml makes measuring easy. 5 ml). 1 ml gives 1 mg, so for a 300 mg dose you’d draw 3 ml. You can adjust the water volume to get any concentration you like; just keep the math consistent. For Kisspeptin‑10 or Gonadorelin you’d usually reconstitute them separately because their stable concentrations differ, but you can use the same type of water for each. Imo, start low, check how you feel
- curious_scientist: I’ve only used NR as a powder you swallow, not as a shot, so I never had to reconstitute it for injection. If you want to inject it you’d need to dissolve the whole 5 mg vial in enough bacteriostatic water to get a concentration you can measure accurately – for example 5 mg in 1 ml gives 5 mg/ml, but that’s far below a 250 mg oral dose, so you’d need many vials to reach that amount. I started with 300 mg oral NR split into two doses and felt a slight lift in afternoon focus, but it could just be
- zone2_nof1: Yeah oral NR sort of skips the reconstitution hassle, just measure the powder. 300mg split into two doses sounds about right for a beginner start. Felt a slight lift for me too, could just be placebo. Worth sticking with that amount a bit before upping.
- fasted_scientist: Glad the oral route seems to lift you a bit – could just be placebo as you say. Thing is I already had the 5mg vial delivered, not loose powder, so I’m still stuck on working out the concentration after reconstitution. 5ml for 300mg across the day split into two. Just wondering if that’s the sort of math most people roll with or if there’s an easier way to gauge it without needing a maths degree before breakfast.
- fasted_scientist: Ngl that bit about the dose math makes me feel a bit silly. I was thinking of injecting this 5mg vial, but I reckon I've completely misread how NR is usually used if people are taking 300mg orally. If I'm just swallowing powder, I don't even need the bacteriostatic water, do I? I'll stick to the oral route for now to avoid the mess.
- restlessemma: Imo, I usually go with 10 mg/ml too – makes the syringe easy to read. For a 300 mg start I pull 3 ml, same as you said. I keep the rest frozen and just use a fresh tip each time. Works fine for me.
- fasted_scientist: Ngl, I think I might have messed up my own maths there. If I want a 300 mg dose from a 10 mg/ml concentration, I would need to pull 30 ml, which is basically the whole vial. I reckon you meant 300 micrograms or something? I am definitely a bit confused about the scale here. Do you usually use a specific syringe for that much volume?
- fasted_scientist: Ngl that math makes a bit more sense now. So if I go with 5ml of water for the 5mg vial like you suggested, I'd just be pulling 3ml for a 300mg dose? That seems like a massive amount of liquid for one go though. Would it be easier to use less water to get a higher concentration so I am not injecting so much volume?
Community discussion - research and educational context only. Not medical advice.