TriMix injection bruising – any tips to reduce soreness and hematoma?

Posted by casey613 in Safety & Side Effects - 14 points, 6 comments.

I’ve been using TriMix for a while now because the oral meds weren’t cutting it for me and I’ve noticed that after a few injections I get quite a bit of bruising around the site, sometimes a small hematoma that lingers for a couple of days. It’s not painful exactly but the discoloration looks nasty and I’m worried about doing long term damage if I keep hitting the same spot. I’ve tried rotating between the left and right side but I’m not sure if I’m spacing them out enough or if the angle of the needle makes a difference.

Does anyone here have a routine that works for them – like icing right after the shot, using a smaller gauge needle, or maybe pressing a clean gauze pad for a minute to stop the bleeding before it spreads? I’m also curious if anyone has checked their bloodwork after regular use and seen any changes in platelets or clotting factors that could explain why I’m bruising more easily. Just looking for practical tips to keep the sides steady while still getting the benefit, any advice would be appreciated.

Comments

• tiredmira: I’ve dealt with similar bruising when I started using injectable peptides for recovery, basically I found that pressing a sterile gauze pad for about 30 seconds right after the shot helps a lot. I also switched to a 30‑gauge needle and make sure the injection angle is pretty shallow, almost parallel to the skin, which seems to reduce the little pockets of blood that turn into hematomas. Rotating sites every 2‑3 days and keeping a small log of where I inject has kept the discoloration from buildi
• weekendnate: I’ve had the same issue and found that a quick ice pack for a minute after the shot cuts the bruising noticeably. I also switched to a 31‑gauge needle and aim for a shallow angle, which seems to keep the hematoma smaller. Rotating every couple days and logging sites has kept things from getting worse.
• casey613: Thanks weekendnate, I’ll try a quick ice pack and switch to a 31‑gauge with a shallower angle. Do you press gauze for a specific time before icing, and have you ever checked platelets or clotting factors after regular use?
• weekendnate: I’ve found that warming the TriMix to room temp before drawing reduces the sting and seems to cut bruising a bit. After the shot I press a clean cotton ball for 45 seconds, then dab a little arnica gel. Rotating every 48 hours has kept my sites looking decent.
• tiredmira: I also warm mine, helps with sting. I do 60 sec pressure and sometimes use vitamin K cream after. Rotating every 48h works for me too. Any tips on needle angle?
• casey613: Appreciate the pressure tip, I’ve been doing maybe 20 seconds so I’ll extend that to a full minute and try the vitamin K cream, never heard of that one before honestly. For angle I go in basically perpendicular to the skin, like 90 degrees, but I’m wondering if I should be more shallow since I keep hitting what feels like small vessels on the way in. You aiming straight down or more at an angle?

Community discussion - research and educational context only. Not medical advice.